Key Specifications/Special Features:

• Temperature: 115 to 140 degrees Celsius (surface of rubber)
• Pressure: 2.0 +/- 0.5 kgf/cm²
• Bonding time: 5 +/- 2 seconds
• Standard type heat seal connector consists of a polyester film as the base material, conductive carbon traces are printed onto the film
• The anisotropic adhesive layer is coated on top of the conductive traces for better insulation and conductivity, this adhesive layer
• is suitable for heat sealing to PCB and LCD
• Hot stamping condition
  • Temperature: 115 to 140 degrees celsius (surface of rubber)
  • Pressure: 2.0 + / - 0.5 kgf/cm²
  • Bonding time: 5 + / - 2 seconds
• Conductive: carbon, silver carbon
• Resistance: < / = 40 ohm, < / = 10 ohm
• Insulation resistance: >100m
• Peel strength:
  • X-Direction (paralell to traces) > / = 450 gf/cm
  • Y-Direction (perpendicular to trace) > / = 200 gf/3mm
  • Peeling angle: 90 degree
  • Peeling speed: 100 mm/min
  • Adhesion width: > / = 3mm

Payment Details: