Key Specifications/Special Features:

• Iron powder molded high current power inductor up to 75A
• Low profile power inductor
• Low DCR SMD power inductor
• Large current up to 45A SMD power inductor
• SMD magnetically shield power inductor
• Shielded SMD power chip inductor
• Magnetic shielded surface mount inductor with high current rating
• Low profile and shielded very effective in space-conscious applications
• Low resistance to deep power loss minimum
• Operating temperature: -20 to 85 degree Celsius (contain heating coil)
• Appearance inspection: no external defect by visual inspection
• Terminal strength: after soldering, between copper plate and terminals of coil, push in two directions of X, Y with standing as below conditions
• Terminal should not peeled off
• Heat endurance of reflow soldering: 240
• Insulating resistance: over 100M ohms at 100V DC between wire and core
• Dielectric strength: no dielectric breakdown at 100V DC for one minute between wire and core
• Temperature characteristic: inductance coefficient (0 to 2,000) x 10-6/(-25 to +80) inductance deviation within ±5.0%, after 96 hours
• Humidity characteristic: in 90 to 95% relative humidity at 40 ±2 and one hour drying under normal condition
• Inductance deviation within ±5.0% after vibration for one hour
• Vibration resistance: in each of three orientations at sweep vibration (10-55-10Hz) with 1.5mm p-p amplitude
• Similar to coil craft and Toko, Sumida, TDK, and Murata brands

Payment Details:

Delivery Details: